Ferrous and Non-ferrous Coating Thickness Gauge TIME®2510

Features:

To obtain non-destructive measurements, magnetic induction (for ferrous materials) and eddy current (for non-ferrous materials) are used as the two operating principles.
To repair the probe’s system inaccuracy, zero point calibration and two-point calibration are used.
DIRECT and BATCH working modes are included, as well as CONTINUE and SINGLE measurement methods.
The mean, maximum, minimum, test numbers, and standard deviation are all included in statistics.
Automatic substrate identification.
600 data are stored.
Deletion of all stored data, including historical data, calibrated data, and limit data.
Error alert and low battery warning.
As an indicator, buzz when operating.
Manual or automatic shutdown.

Specifications:

Probe types		F	N
Working principle		Magnetic induction	Eddy current
Measuring range		0-1250 μm	0-1250 μm, 0-40μm (for chrome plate on copper)
Minimum resolution		0.1μm
Tolerance	Zero point calibration	±(3%H+1) μm	±(3%H+1) μm
		H means the thickness of tested piece
	Two points calibration	±{(1-3)%H+1}μm	±{(1-3)%H+1}μm
		H means the thickness of tested piece
Measuring condition	Min. curvature radius	Convexity 1.5 mm	Convexity 3 mm
	Min. area diameter	Φ7 mm	Φ5 mm
	Critical thickness of the base	0.5 mm	0.3 mm
Operating environment		Temperature: 0℃- 40℃
		Humidity: 20%-90%
		No strong magnetic field
Power		2 pcs AAA 1.5 V battery
Dimension		110 x 50 x 23 (mm)
Weight		100 g